Wheel center cap 63 MM and logo Carbon Red

How to select correct type of 63 mm wheel center cap with Carbon Red logo

1. Measure A, B, C on your existing cap according to this drawing:

*** if you do nor have any caps, you need to measure your wheel. Manual is HERE.

               Click to enlarge

2. Prepare your measured values ​​of A, B, C and compare with right part of the table

- start with comparing dimension C, that will narrow your options to one or few variants
- then continue with dimension B, that will again narrow to one or maybe to caps variants
- and as last compare dimension A.

At this point you should have only one cap in your scope. If there might still be two options
compare also dimensions  D, E and F and select one with dimensions that fit  the best.

3. Write down selected center caps type add it to your order

If you need advice, send us email with the dimensions you have measured.

Overview of wheel center cap types with diameter 63 mm									COMPARE YOUR MEASUREMENTS WITH BELOW RANGES In order to have the center cap fit your wheels, dimensions A, B and C measured by you   MUST BE within all three  A, B and C tollerances.
SPECIFICATION
Cap type to order	Photo click to enlarge	A	B	C	D	E	F		A	B	C
1009		63,5	61,0	2,5	4,0	6,0	4,0		63,3 - 64,0 mm	60,8 - 61,2 mm	2,5 - 2,9 mm
1014		63,5	52,0	3,3	7,0	10,2	1,6		63,3 - 64,0 mm	51,8 - 52,2 mm	3,3 - 3,7 mm
1029		64,0	58,0	3,5	6,5	10,0	2,3		63,8 - 64,5 mm	57,8 - 58,2 mm	3,5 - 3,9 mm